Mr. Cement SP (Super Power) is GSI Creos's fast-bonding, low-viscosity cement for plastic models. Like Mr. Cement S, it flows into the seam between two parts through capillary action. The SP formulation cures significantly faster and grips styrene plastic harder, so the bond is ready to handle in less time and holds up better under stress.

The formula is tuned specifically for melting styrene resin, which means it fuses parts chemically rather than acting as surface glue. That matters most when you're joining pieces with large contact areas: tank turret halves, aircraft wings, ship hulls, Gunpla armor panels that need to take real load. It also saves joins where the mating surfaces barely touch and regular cement struggles to hold.

The cap has a fine-tip brush built in for detail work, so you can apply exactly where needed without flooding the part. For broader areas, switch to a separate round or flat brush. Pair it with the slower Mr. Cement S when you need time to adjust alignment before setting, and reach for SP when you need the bond to lock down fast. 40ml bottle goes a long way.

How to Use

Dry-fit your parts first and hold them together firmly. Touch the brush tip to the seam and let capillary action pull the cement into the gap. You don't need much. Work in a ventilated space, keep the cap closed between applications, and avoid direct skin contact. For curved surfaces or large flat joins, load a round brush separately instead of relying on the cap brush. Give the bond at least a few minutes before handling and a full day before stressing it. For fine-adjustment scenarios, switch to the slower-drying Mr. Cement S instead.

General Specifications