GP-G05-1-S2 (Ref. code)

GP-G05-1-S2 (EAN-13)

GUNPRIMER - GRIDA SET V2.0

GUNPRIMER - GRIDA SET V2.0
GUNPRIMER - GRIDA SET V2.0
GUNPRIMER - GRIDA SET V2.0
GUNPRIMER - GRIDA SET V2.0
GUNPRIMER - GRIDA SET V2.0
Status: NEWIN STOCK  (1) Delivery in 24/48 hours
+30 Points
29,95
21.00% VAT included
unidades

Add to Shoppingcart

Weight: 100 grams

GRIDA 

Premium Scribing Set

Includes 

1.- Micro Chisel
2.- Mechanical Holder
3.- Master Guide 2.0

Each GRIDA set includes a handmade certificate of authenticity and MASTER GUIDE 2.0 sheet. Because of the precision and craftsmanship required to attain the highest quality possible, only 10 of this product is produced per day.
The MASTER GUIDE 2.0 can be used in conjunction with the GRIDA to create new panel lines. Please refer to the link below for more information about the product.

MICRO CHISEL Size: 0.5x30mm Material: Carbon steel Made in Korea

  • MICRO CHISEL is a product developed exclusively for panel line scribing. Install and use it with the enclosed MECHANICAL HOLDER.
  • MICRO CHISEL's multi-directional technology enables scribing as if drawing on a paper.
  • MICRO CHISEL is capable of scribing an average of 0.15~0.2mm panel line which is the most preferred thickness for panel lines in plastic model kits.

 

MECHANICAL HOLDER Size: 10x135mm Made in Japan

  • MECHANICAL HOLDER is a dedicated tool to use with the MICRO CHISEL. Balanced weight and handling make possible for more elaborate work.

  • Rubber grip of the MECHANICAL HOLDER prevents from slipping while scribing.

  • Designed for extra level of safety, Double-Tap Sleeve Technology ensures the safety for both the user and the MICRO CHISEL.

     

    INSTALLATION
    Hard press on the MECHANICAL HOLDER extends the safety sleeve and subsequent light press extends the MICRO CHISEL and another hard press retracts the sleeve back into the HOLDER. It's full retraction mechanism prevents from any damage of MICRO CHISEL when not in use.

 

IMPORTANT

  • Do not over extend the chisel from the grip. This may cause damage or break the chisel. It is recommended to click the holder 3 times after inserting the MICRO CHISEL to get the proper length for use.
     

  • Holding the MECHANICAL HOLDER improperly in low or steep angles will not give good results and may break the chisel. It is recommended to hold MECHANICAL HOLDER, upright, as if you are writing or drawing.